queue jump造句

例句与造句

1. Queue jumps are only effective in certain situations.
2. The length of the queue jump lane needs to be long enough to provide a meaningful time savings.
3. If the queue jump lane is designated as bus-only, then standard traffic signal detection such as loop detectors or video detection can be used.
4. Pedestrian phases can generally run concurrent with a queue jump phase as long as there are no protected turn phases also running with the queue jump phase.
5. Pedestrian phases can generally run concurrent with a queue jump phase as long as there are no protected turn phases also running with the queue jump phase.
6. It's difficult to find queue jump in a sentence. 用queue jump造句挺难的
7. In the short term, transit signal priority and queue jump lanes are being constructed and will be rolled out as features of the bus rapid transit service.
8. In 2012, a queue jump signal was installed northbound at the north end of the BAT lanes at 148th Street, allow Swift buses to merge into traffic.
9. Queue jumps can also be used in situations such as bus stop pullouts or at the end of a bus-only lane, in order to help expedite the bus merge into traffic.
10. First, there has to be an existing source of delay or roadway congestion; if there is no congestion and the normal traffic signal is usually green, then the bus driver has no reason to move into the queue jump.
11. The service differs from the Rapid Ride based on the fact that it would be considered a true BRT service based on adding more aspects of BRT service such as a dedicated travel lane or queue jumps, platforms level with the bus floor, and off-board ticketing so that passengers can load at any door.
12. Queue jumps may not work well where there are high volumes of right turning vehicles ( left turning in UK ) that might get in the way of the bus through movement, although in some cases these turning vehicles can be provided a separate lane and / or a protected signal phase at the same time as the advanced transit phase.
13. If there is a limited amount of other traffic in the lane, then two or more loop detectors can be used and configured with Opticom or RFID . Queue jump advance phases are typically 5-10 seconds in duration; longer time may be needed if multiple buses or right turning traffic need to be flushed through the queue jump in one signal cycle.
14. If there is a limited amount of other traffic in the lane, then two or more loop detectors can be used and configured with Opticom or RFID . Queue jump advance phases are typically 5-10 seconds in duration; longer time may be needed if multiple buses or right turning traffic need to be flushed through the queue jump in one signal cycle.